Tag: Equipment

Center Hole

doctorGeneral

After this bit of the same diameter (can be broken in half, which is typically not released in the hope of sharpening if necessary) need to sharpen a chisel. Initially, at a distance of 6 and – 8 mm from the end of the grinding wheel carved rectangular cross section with a width of about 2 – 3 mm. Then butt whittle away at an angle of 20 degrees, while giving the same right angle side of the face. Later you can adjust the size of the tool depending on the diameter cut holes. In the disk, fake ray bans you can not drill a single hole (slot) at different distances from the axis, depending on the size cut a hole. Perpendicular to the jacks in the middle of the thickness of the need to drill a hole diameter of 3.5 mm along the radius.

Then, using the tap M4 chop it and screw thread corresponding to the bolt that secures the cutter in the nest. Nozzle is ready, but so far only for the hole the same size. nfl jerseys cheap The center planned to cut the holes to make cheap football jerseys china Punch and drill a recess at this point through-hole drill a small diameter (2 – 3 mm). It is desirable to заварной consolidate the clamp drilled sheet on the bench, put it under him a couple of sheets of hardboard. If the hole Cheap Oakleys in a place that secure clamp is not possible to have screwed with two screws and a sheet dwt to the bench. Then drill a sheet of fiberboard and a drill the same diameter as the shaft (shaft) drive. Holding one end of the axis of the disk in a cartridge electric drills, pass the other end into the hole drilled in the center of the circle cut out and including an electric drill, start to cut out a circle, holding the drill perpendicular to the plane. Once cut a circle cheap nfl jerseys (the puck, in fact, that may be useful for something), the sheet will be opening the correct form with given diameter.

ACS LNL Controller

doctorGeneral

The company Lenel Systems International has introduced a new controller ACS LNL-2210 to limit wholesale jerseys access through one Cheap Oakleys door, which is designed to service one or two readers Cheap MLB Jerseys of ID cards. Novelty has a network interface Ethernet 10/100 Base-T, supports the OSDP and can work as part of an integrated security system Lenel OnGuard. Due to the volatile memory of 6 MB, the controller may store information on 240,000 cardholders access and 50 000 events. Except addition, the unit has inputs for door position monitoring and request to exit buttons, and has additional outputs for lock and alarm equipment, access control systems. In memory of the network controller may be stored Lenel about 240,000 cardholders access, and configuration settings LNL-2210 and the event log to 50 cheap football jerseys 000 records, which can be used, for example, for time.

To ensure the safety information in case device is wholesale football jerseys installed back-up battery, which can be activated in case of power failure. In addition, the controller is equipped with flash memory for software upgrade ACS. The new controller Lenel can serve up to 2 readers, that allows you to carry two-way identification of visitors, both at the input and output. The device can be used with contact or contactless readers access card interface Wiegand or RS-485 most reputable manufacturers. These are models with biometric user identification, magnetic stripe Everyone readers, etc. To take full advantage of readers of various brands of LNL-2210 provides 8 different card formats. Monitoring and remote management controller and the devices attached to readers over a network Ethernet (10/100 Base-T) through the system interfaces Lenel OnGuard security using the first open standard OSDP (Open Supervised Device Protocol).